HP 5036A MICROPROCESSOR LAB
I bought the 5036A on eBay UK after looking for one for nearly 2 years. The original cost was $800 in 1980. This is a training course for microprocessor hardware, software and troubleshooting. The 5036A is also required for testing the 5004A & 5005A Signature Analysers and the 1630D/G Logic Analysers.
The 5036A is in very good condition and only required a good clean-up and a couple of minor damage items repairing. This is a late model S/N 2212A version which has the case locking latches on the side instead of the front of the brown briefcase (earlier S/N was 1848A) and is complete with a key.
The µP Board is held on a tray inside the case by a plastic latch and 2 hinge clips. 4 screws hold the tray to the case. The tray can be lifted out but the µP Board is hard wired to the Power Supply Unit underneath. The PSU and its 2 mounting brackets can be removed with another 8 screws. The PSU has an On/Off Switch, Voltage Selector, Fuse and Power CEE22 Connector. Power connections to the µP Board are YL/WH +5V, BK/WH 0V, OR/WH +5V. Fitting an in-line power connector for the dc supplies would be a good idea for ease of access and maintenance.
The 5036A comes complete with a book "Practical Microprocessors, Hardware, Software and Troubleshooting" by Michael Slater and Barry Bronson (now available from Artek Media) which is kept in a pocket inside the briefcase lid. This book is the 4th printing of April 1981 and contains 454 pages.
The book contains 20 lessons and various appendices. Studying this book is intended to achieve the following objectives: a) Acquire a practical knowledge of microprocessor system hardware; b) Gain a basic understanding of the software that is used to control a microprocessor system; c) Learn how the system uses this software to perform a wide variety of operations; d) Use this information to learn practical troubleshooting techniques that are applicable to any microprocessor system.
The 5036A utilises the Intel 8085 8-bit µP and also mentions its contemporary Intel 8080, Zilog Z80, Motorola 6800, MOS 6500, Fairchild F8 and Texas TMS1000. Although these are all now obsolete, the book will provide a useful µP refresher course for me.
The 5036A was intended to be used by reversing the lid of the case on the hinges to create an A frame and secured with a strap, or the pcb can simply be used outside of the case, or just used in the bottom half of the case.
Completed Lessons: 1 Introduction to Microprocessor Systems; 2 Number Systems; 3 Software Fundamentals; 4 Using the Microprocessor Lab; 5 Basic Software Concepts. All straightforward providing you have previous experience with digital electronics.
Delayed by other projects, so had to revise Lessons 1 to 5. Then completed Lessons: 6 Inside The Microprocessor; 7 Basic hardware Concepts; 8 Address Decoding; 9 Memories & Peripherals; 10 Control Circuits; 11 Registers and Breakpoints; 12 The 8085 Instruction Set; 13 Software Design Techniques; 14 Software Control of Peripherals; 15 Number Representations and Algorithms; and 20 Microprocessor Survey. Again, these are all straightforward providing you have previous experience with digital electronics, plus programming and mathematics!
The remaining lessons 16 to 19 are concerned with trouble-shooting techniques and test equipment. These will get a quick overview, but I will leave them until I have my new bench and test equipment available.
Also included in the Book are Appendices: A Solutions to Problems; B 8085A Instruction Set Reference; C Signature Tables; D Reading Logic Diagrams; E Demonstration and Utility Programs; F Microprocessor Lab ROM Listing; G Expanding the Microprocessor Lab; H IC Data Sheets; plus a Glossary, Bibliography, Hardware Reference Diagrams, and a Quick Reference Chart.
In conclusion, even after some 30+ years, a useful course in microprocessor hardware and software, a lot of which will be relevant to current µP's. Also the 5036A provides a convenient testbed for exercising logic analysis test equipment.
Return to Current Projects